Gas generator start-up and shut-down operation has a lot to pay attention to, below the methane desulfurization equipment manufacturers to summarize for you, I hope you can read carefully, to help you!
一、准备工作
I. Preparations
1、检查燃气发电机的预热系统、水循环系统是否正常；
1. Check whether the preheating system and water circulation system of gas generator are normal.
2、检查气路上各阀门的状态，检查发电机通负载电路开关状态；
2. Check the status of the valves on the gas path and the on-off status of the load circuit of the generator.
3、检查发电机组是否固定牢固，各个电线接头有无脱落。
3. Check whether the generator set is fixed firmly and whether the connection of each wire has fallen off.
4、检查机组机油，冷却水、电池液是否足够，有无渗漏；
4. Check whether the oil, cooling water and battery liquid are enough and whether there is leakage.
5. Check the battery voltage on the display screen and alarm if there is a fault. If there is a fault alarm at present, after eliminating the fault, cancel the alarm, otherwise the generator can not start.
二、操作要求
II. Operational requirements
1、熟悉发电机操作步骤，严格执行本作业指导卡；
1. Familiar with generator operation procedures, strictly implement the operation guidance card;
2、启动后必须定时观测机组工作状况。
2. The working condition of the unit must be observed regularly after start-up.
三、操作步骤
III. Operational steps
㈠ 启动燃气发电机
A Start-up Gas Generator
1、打开气路上所有阀门，调整进发电机天然气压力至15mbar（1.5KPa）左右；
1. Open all valves on the gas path and adjust the natural gas pressure into the generator to about 15 bar (1.5 KPa);
2、旋转控制面板上按钮至“启动”位置，启动发电机；
2. Rotate the button on the control panel to the "start" position and start the generator.
3、机组启动后检查各参数显示是否正常（电压、频率、水温、油压等），机组各部分有无渗漏；
3. Check whether the parameters of the unit are normal (voltage, frequency, water temperature, oil pressure, etc.) and whether there is leakage in each part of the unit after start-up.
4、闭合机组输电开关，给负载供电；
4. Close the transmission switch of the unit to supply power to the load.
5、每30分钟，记录运行参数（水温、油压、电压、电流等）。
5. Record operation parameters (water temperature, oil pressure, voltage, current, etc.) every 30 minutes.
㈡ 停燃气发电机
Gas Generator with Two Stops
1、断开发电机的负载开关，使机组空载运行5分钟；
1. Disconnect the load switch of the generator to make the unit run for 5 minutes without load.
2、旋转控制面板上按钮至“停机”位置。
2. Rotate the button on the control panel to the stop position.
Well, today's wonderful content is introduced here. If you have any questions, please consult the official website customer service staff of biogas desulfurization equipment: https://www.hneee.net.
企业二维码
2019-05-10
鲁公网安备37011202000764号号